Alaska Area
Phone (907) 290-1555
Toll Free (800) 767-6700
Fax (206) 767-6230

Raised Face & Flat Face Flanges

Raised Face and Flat Face Flanges (Mating Combinations)

Pumps of cast iron construction are furnished with 125 or 250 lb. flat face (F.F.) flanges. Since industry normally uses fabricated steel piping, the pumps are often connected to 150 or 300 lb. 1/~6 raised face (R.F.) steel flanges.

Difficulty can occur with this flange mating combination. The pump flange tends to pivot around the edge of. the raised face as the flange bolts are tightened. This can cause the pump flange to break allowing leakage at the joint. (Fig. 1).

sect i7 fig1
fig. 1
A similar problem can be encountered when a bronze pump with F.F. flanges is connected to R.F. steel flanges (Fig. 2). Since the materials are not of equal strength, the bronze flange may distort, resulting in leakage.

sect i7 fig2
fig. 2
To avoid problems when attaching bronze or cast iron F.F. pump flanges to R.F. steel pipe flanges, the following steps should be taken (refer to Fig. 3).

sect i7 fig3
fig. 3
1. Machine off the raised face on the steel pipe flange.
2. Use a full face gasket.

If the pump is steel or stainless steel with F.F. flanges, no problem arises since materials of equal strength are being connected. Many customers, however, specify R.F. flanges on steel pumps for mating to R.F. companion flanges. This arrangement is technically and practically not required.

The purpose of a R.F.vflange is to concentrate more pressure on a smaller gasket area and thereby increase the pressure containment capability of the joint. To create this higher gasket load, it is only necessary to have one-half of the flanged joint supplied with a raised face - not both. The following illustrations show 4" steel R.F. and F.F. mating flange combinations and the gasket loading incurred in each instance.

Assuming the force (F) from the flange bolts to be 10,000 lbs. and constant in each combination, the gasket stress is:

sect i7 equat1

sect i7 fig4
fig. 4

sect i7 fig5
fig. 5

sect i7 fig6
fig. 6
It can be readily seen that the smaller gasket, used with a raised face flange, increases the pressure containment capability of a flanged joint. However, it can also be noted that there is no difference in pressure capability between R.F.-to-R,F. and R.F.-to-F,F. flange combinations. In addition to being technically unnecessary to have a R.F.-to-R.F. mating combination, the advantages are:

1. The elimination of the extra cost for R.F. flanges.
2. The elimination of the extra delivery time required for a non-standard casing.